CISCO MDS 9124 CONFIGURATION GUIDE PDF

Example Cisco MDS Switch Default Port License Configuration. switch# show port-license Available port activation licenses are 0. Cisco MDS Family Quick Configuration Guide. OL Using the Switch Setup Utility Verifying the Module Status CHAPTER. 3. Configuring. Note If a Cisco MDS or switch is used as a core switch, only a nontrunking F PortChannel is supported. Trunking is not supported on.

Author: Dagrel Voodoobar
Country: Liberia
Language: English (Spanish)
Genre: Education
Published (Last): 1 July 2005
Pages: 365
PDF File Size: 16.9 Mb
ePub File Size: 13.15 Mb
ISBN: 851-3-97437-711-9
Downloads: 6266
Price: Free* [*Free Regsitration Required]
Uploader: Gogal

Then states two bullets later: Previous blog entries also dealt with storage, compute, virtualization and professional services. You must be logged in to post a comment. This should be made more clear. If you assign port number for physical portshow can you assign for ports ? Should be 8 base ports, which can goto 8 or 16 additional ports. On the gukde page I find this block of text very vague and confusing: The way its written sounds like xisco you have a large scale deployment where you need explicit LUN access control you can use proxy-initiator, but its really the opposite.

  ATLAS ZBUNTOWANY PDF

I am not sure if this is valid.

Page shows with 8 base ports 8 licensed for growth. Testing indicates that this is in fact enabled by default. If you enabled the autoreconfigure option on both switches before connecting the fabric, a disruptive configuratoon RCF will occur.

Have a few different cisvo read that and I think you will see where I am coming from. Certainly there is either a mistake in the wording or the example. I am not sure. There is no information contained in the example given that shows the configuration or enabling of FCIP interfaces.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata

Page Document states: You cannot mix ingress and egress interfaces in the same SPAN session. Proudly powered by WordPress.

The opinions expressed in this blog are entirely my own and should not be taken as the opinion of my employer. You can nondisruptively reconfigure the fcdomain by changing the configured domains on the overlapping links and getting rid of the domain overlap.

From time to time I will blog about other things of interest. Obviously there was a part of this paragraph that got chopped off somewhere. About System Message Logging properly configured system message logging server. You do not need to restart the fcdomain.

  IL BARONE DI MUNCHAUSEN PDF

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata – Maximum Entropy

This is not true. Page Information is repeated twice on the same page: Reconfiguration as in changing of domains is always disruptive. This blog is mostly about my confgiuration in Data Science. This page incorrectly states that you can disable password verification with aaa authentication login none command.

Page Figure shows incorrect ip default-gateway Page States in one bullet: These pages talk about an active mode of fcanalyzer. Should say Step 1 Enable the mgmt 0 interface. FCIP uses different ports.

A disruptive reconfiguration may affect data traffic. This is very redundant and can be combined into one bullet. This page incorrect states that fcns reject-duplicate-pwwn is disabled by default. This is not correct as this does not work. Cisco Documentation team has internally re-written this as: